GCB-132/1321 4'/4'6/5'Bed Frame Assembly Guide

GCB-T32I Bed Frame Assembly Guide

Congratulations on your new bed! Follow these steps to assemble it safely and effectively.

Before You Begin:

• The bed frame comes in 3 cartons (KD style).

• Check all parts and tools on page 2 before you start.

• Assemble on a level, even surface.

• Do not use power tools—they may damage the frame.

• Secure all bolts loosely at first; only tighten them fully after assembly is complete.

Safety and Care Advice:

• Always lift the bed with two people.

• Keep small parts away from children.

• Stop using the bed if any parts are missing, damaged, or worn.

• Periodically check and tighten screws to ensure the frame is secure.

• Keep the bed away from direct sunlight.

• Clean with a cloth and mild detergent.

WARNING: If using on a non-carpeted floor, place feet pads under all legs to prevent movement and potential collapse.

Parts and Hardware (Box 3):

Assembly Steps:

1. Position the side rails next to the headboard and footboard, and secure with corner brackets using bolts A. Fix the angle brackets to the footboard, then attach the crossbar to the side rails.

2. Secure the gas piston set to the side rails using bolts A and nuts C.

3. Insert the frame joint caps into the gas lift frame. Attach the central support bar to the middle of the frame using nuts C and bolts D.

4. Attach the gas lift frame onto the gas piston set using bolts B.

5. Slot the slats into the end slat caps and central slat caps, then press them into place on the sidebars.

6. With two people, tilt the bed frame and attach the fabric base. Check all parts are positioned correctly, then fully tighten all bolts. Assembly is now complete!

Need Help?
For missing or damaged parts, please contact the retailer where you purchased the bed for assistance.

Download PDF