GCB-113 4'6/5' BED Step-By-Step Guide

Bed Frame Assembly Guide

Congratulations on your new bed frame! Before you start assembling, please read these instructions carefully to ensure a smooth and safe assembly.

Important Assembly Tips:

• The bed frame is packed in 3 cartons (KD style).

• Check all parts and tools listed on page 2 before beginning.

• Assemble on a level, even surface.

• Do not use power tools—they may damage the frame.

• Loosely secure all bolts and parts first; tighten them fully only once the frame is complete.

Safety and Care Advice:

• Always lift the bed with two people to reposition it safely.

• Keep small parts out of reach of children.

• Stop using the bed frame if any parts are missing, damaged, or worn.

• Periodically check all screws and fixings to keep the frame secure.

• Keep the bed away from direct sunlight.

• Clean with a cloth and mild detergent.

WARNING: If placing the bed on a non-carpeted floor, use feet pads under all legs to prevent the frame from moving. Failure to do so may void any warranty against collapse.

Parts and Hardware (Box 3):

Assembly Steps:

Step 1: Remove the fittings box from the back of the headboard by pulling off the magic tape, then re-stick the tape.

Step 2: Position the side rails adjacent to the headboard and footboard with corner brackets, and secure using bolts A.

Step 3: Attach the central support bar to the headboard and footboard using bolts A. Insert the support legs into the holes on the central support bar using bolts B, nuts D, and washers E.

Step 4: Slot the slats into the end slat caps and central slat caps as shown. Attach the slats to the side rails and central support bar, then press firmly into place. Once everything is in place, fully tighten all bolts. Assembly is now complete.

Need Help?
If you have any issues or missing parts, please contact the retailer where you purchased the bed frame for assistance.

Download PDF