GCB-103 4'6" and 5' Bed: Step-by-Step Guide

How to Assemble the GCB-103 4'6" and 5' Bed: Step-by-Step Guide

Assembling your GCB-103 bed can be straightforward if you follow the steps carefully. Here’s a clear, step-by-step guide to help you build your bed securely and correctly.

Before You Begin:

• Inventory Check: Confirm all parts and tools listed in the instructions are present.

• Flat Surface: Assemble on a level, even surface to ensure stability.

• No Power Tools: Avoid using power tools as they may damage the bed frame.

• Loose Fit: Secure all parts loosely first; fully tighten them only after the frame is completely assembled.

Safety and Care:

• Always lift the bed with two people when repositioning.

• Keep small parts out of reach of children.

• Do not use the bed frame if any parts are missing, damaged, or worn.

• Periodically check all screws and fixings to keep the frame secure.

• Keep the frame away from direct sunlight.

• Clean with a cloth and mild detergent.

• Warning: If placed on a non-carpeted floor, use feet pads under all legs to prevent slipping. Not doing so may compromise the frame’s stability.

What’s in the Box?

• Bed Components: Headboard, footboard, left and right side rails, metal legs, support legs, central support bars, corner brackets, slats, end slat caps, and central slat caps.

• Hardware: M8x25mm bolts, M8x35mm bolts, M4x35mm bolts, M8 nuts, washers, M5 Allen key, M14 spanner, and a screwdriver.

Assembly Steps:

Step 1:

• Secure the metal legs to the bottom of the headboard and the two side rails using M8x35mm bolts (B) and M4x35mm bolts (C) with the help of the screwdriver.

Step 2:

• Attach the side rails to the headboard and footboard using the corner brackets and M8x25mm bolts (A).

Step 3:

• Connect the central support bar to the headboard and footboard using M8x25mm bolts (A).

• Insert the support legs into the holes on the central support bar using M8x35mm bolts (B), M8 nuts (D), and washers (E).

Step 4:

• Slot the slats into the end slat caps and central slat caps as shown.

• Secure the slats to the side rails and central support bar, and press them firmly into place.

• After confirming all parts are properly positioned, fully tighten all bolts.

Final Notes:

• After assembling, inspect all bolts and nuts to ensure everything is tight and secure.

• If any parts are missing or damaged, contact the retailer you purchased the bed from to resolve the issue.

By following these steps, you’ll have a solid and comfortable bed frame ready for use. Enjoy your new GCB-103 bed!

Download PDF