GM-1301 Bed Frame Assembly Guide

GM-1301 Bed Frame Assembly Guide

Congratulations on your new bed! Please follow these steps to assemble it safely and properly.

Before You Begin:

• The bed frame comes in 1 carton (KD style).

• Check all parts and tools listed on the second page before starting.

• Assemble on a level, even surface.

• Avoid using power tools—they may damage the frame.

• Loosely secure all bolts at first; only fully tighten them when the assembly is complete.

Safety and Care Advice:

• Always lift the bed with two people to reposition.

• Keep small parts away from children.

• Stop using the bed if any parts are missing, damaged, or worn.

• Periodically check and tighten all screws to ensure the frame is secure.

• Keep the frame away from direct sunlight.

• Clean with a cloth and mild detergent.

WARNING: On non-carpeted floors, use feet pads under all legs to prevent the bed from moving and potential collapse.

Assembly Steps:

Step 1:

• Attach the plastic legs to the bottom of the headboard and tighten with the Allen key.

• Connect the side rails A and B with the cross bar using bolts and tighten.

• Attach the side rails to the headboard and footboard using bolts, spring washers, and washers, then tighten.

• Secure the side support legs to the bottom of the side rail frame using bolts and tighten.

Step 2:

• Attach the central support bar to the middle of the headboard and footboard using bolts and tighten.

• Secure the end support legs and center support leg to the bottom of the cross bar using bolts and tighten.

Step 3:

• Slot the slats into the end slat caps and central slat caps as shown.

• Attach the slats to the side rails and central support bar, then press them firmly into place.

• Once all parts are positioned, fully tighten all bolts. Assembly is now complete!

Need Help?
If you have missing or damaged parts, please contact the retailer where you purchased the bed for assistance.

Download PDF