GCB-114 4'/4'6/5' BED Step-By-Step Guide

Bed Frame Assembly Guide

Congratulations on your new bed frame! Please follow these assembly instructions carefully to ensure a smooth and safe setup.

Important Tips:

• Your bed frame comes in 3 cartons (KD style).

• Check all parts and tools listed on page 2 before you start.

• Assemble on a level, even surface.

• Do not use power tools—they could damage the frame.

• Secure all bolts loosely at first; only tighten them fully after completing assembly.

Safety and Care:

• Always lift the bed with two people to reposition it safely.

• Keep small parts away from children.

• Stop using the bed frame if any parts are missing, damaged, or worn.

• Periodically check and tighten all screws and fixings.

• Keep the bed away from direct sunlight.

• Clean with a mild detergent and cloth.

WARNING: If placing the bed on a non-carpeted floor, use feet pads under all legs to prevent movement and potential collapse.

Parts and Hardware (Box 1):

Assembly Steps:

1. Remove the fittings box from the back of the headboard by pulling off the magic tape, then re-stick the tape.

2. Attach the wooden legs to the bottom of the headboard and footboard using bolts C.

3. Position the side rails adjacent to the headboard and footboard with corner brackets, securing them using bolts A.

4. Attach the central support bar to the headboard and footboard using bolts A. Insert the support legs using bolts B, nuts D, and washers E.

5. Slot the slats into the end slat caps and central slat caps as shown. Attach them to the side rails and central support bar, then press firmly into place.

6. Fully tighten all bolts once everything is positioned correctly. Assembly is complete.

Need Help?
If you have damaged or missing parts, please contact the retailer where you purchased the product for assistance.

Download PDF